About
Most small speakers hand you a row of identical rubber buttons and hope you memorise which is which. The NATTBAD has one knob, and the knob does nearly everything.
IKEA's NATTBAD is a mains-powered Bluetooth speaker built around a single 2.8 inch full-range driver, controlled almost entirely by that one dial. Turn it for volume. Press once to pause or play, twice to skip forward, three times to go back, and hold it down to pull a second NATTBAD into multi-speaker mode, where every speaker in the group plays the same mono feed. The only other button belongs to Spotify: press it and whatever you last listened to resumes, press it again and the app pulls something different out of your listening history. Neither action requires unlocking your phone.
The numbers set the expectations honestly. Total output is 10 watts, the frequency range runs 75 to 18,500 hertz measured at minus six decibels, and the loudest it goes is 81.2 decibels, which is a room rather than a garden. There is no battery. A two metre mains lead comes out of the back and the speaker draws 0.3 watts sitting idle, so it stays where you put it and stays plugged in.
IKEA rates it IP20, which is the specification's way of saying this is an indoor object and should be treated as one. The stated working distance is ten metres or more in open air, both between phone and speaker and between two speakers in a group, so a grouped pair can sit in adjoining rooms rather than the same one.
- Designed in
- Sweden
- designer
- Jon Eliason
- Made in
- China
- Material
- Dimensions
- 12 cm wide, 18 cm high, 9 cm deep
- Range
- At least 10 m without interference
- Power reserve
- Mains only, 2 m lead, 0.3 W idle
- Noise
- 81.2 dB maximum
Figures as published by the manufacturer. Source




















