About
A weight stack can only pull down, and only in whole plate steps. That is the constraint every home gym is built around, and it is the one Amp deletes.
The Amp Device is a cable machine that bolts to a wall and carries no plates at all, setting resistance to the pound from an app instead, up to 100 pounds on a single adjustable arm. Amp says the load adapts as you move and that every rep is counted as it goes. The arm locks at 40 points along its vertical travel, which is the detail that lets one machine handle a sumo squat down at floor level and a Y raise overhead without any of the usual rethreading and repinning. Power comes from a standard 120 volt outlet. The app reaches the unit over wi-fi and bluetooth, and a charging hub on the body keeps a phone alive through a session.
Installation is eight small holes into two studs, done in about 45 minutes by a technician Amp sends at no extra cost. Five accessories arrive with it: a T-bar, a rope, ankle straps, a dual handle and a single handle, between them covering tricep pushdowns, back extensions, step downs, chest presses and single-arm rows. An aluminium accessory rack is sold separately at $110.
The app is the part to weigh up before the hardware. It runs on iPhone and iPad, holds more than 700 exercises, covers up to 15 profiles in one household, and costs $36 a month on a twelve month commitment, which is to say the machine on the wall is only half of what you are buying.
- Designed in
- United States
- Materials
- Range
- Resistance up to 100 lb
- Size
- 3 ft of wall width by 7 ft of height
- Controls
- App over wi-fi and bluetooth; iPhone, iPad
- Also charges
- Phone, via onboard hub
Figures as published by the manufacturer. Source














