About
Most air purifiers are sold on the filter, which is a bit like selling a boat on the quality of its timber. Air that slips past a seam or a badly seated panel leaves the top of the machine as dirty as it arrived, and that is the quiet failure mode of the whole category.
The Dyson Purifier Humidify+Cool is built to HEPA H13 standard as a whole machine rather than as a filter, which means the seals and joins are held to the same specification as the media. Dyson closes the paths air could take around the cartridge, then tests for them: the assembled machine is challenged with DEHS oil to EN1822 inside a chamber built to ASTM F3150. The filter itself is a single 360 degree cartridge, glass HEPA catching 99.97 per cent of particles down to 0.3 microns, wrapped around activated carbon for gases and odours, and replaced whole rather than in parts.
Humidifying is where machines like this usually go wrong, because standing water grows things. This one evaporates water instead of misting it, so nothing visible leaves the machine at all, and a deep clean cycle flushes mineral build-up out of the entire water system on a schedule worked out from the water hardness you enter in the app. Three sensors read the room without pause, and the fan reacts before the screen reports what it found. Dyson runs its own tests in an 81 cubic metre room with nine sensors, against the industry chamber of 28.5 cubic metres and one, which tells you something about how much of this category's data is gathered in a cupboard. The curved remote is magnetised and parks on the top of the loop.
- Designed in
- United Kingdom
- Made in
- Malaysia
- Material
- Glass HEPA and Activated Carbon Filter
- Dimensions
- 36.33 in H × 12.28 in L × 11.02 in W
- Weight
- 18 lb
- Capacity
- 1 gallon water tank
- Controls
- 10 speed settings, remote, MyDyson app, voice services
Figures as published by the manufacturer. Source


















