About
A cordless screwdriver is usually sold on how much it can turn. This one is sold on how little.
The Hoto Electric Precision Screwdriver ADV spins at 170 rpm and stops dead at 0.2 newton metres, which is enough to drive a laptop screw and not enough to tear the head off one. A toggle on the barrel picks between two settings: 0.05 newton metres for spectacle hinges and ribbon connectors, 0.2 for a screw that has been seated a while. When the motor gives up you keep turning by hand, and the body takes up to 3 newton metres that way, so the last quarter turn on a tight fastener is yours to judge rather than the motor's. The light at the nose sits around the bit instead of beside it, which is why Hoto calls it shadowless: nothing falls across the recess you are aiming into.
Twenty-five bits come in the case, C4 shanks 28 millimetres long in S2 alloy steel hardened to 60 HRC. The spread is wide before it is deep: five Phillips, four hex, two slotted, three Torx and five security Torx with the pin hole drilled, two pentalobe, and one each of Pozidriv, Y, tri-wing and triangle, for the fasteners that exist to keep people out. They sit in the lid by magnetism alone, dropped into a slot and held. One patch of the case is a magnetiser, and five seconds against it puts the pull back into a bit that has gone weak.
Charging is USB-C from a 5 volt supply, with an indicator that flashes red under 20 percent and holds white when the battery is full.
- Designed & made in
- China
- Controls
- Two torque settings, 0.05 and 0.2 Nm, at 170 rpm
- Charging
- USB-C, 5 volt supply
- Material
- Size
- C4 shanks, 28 mm long
Figures as published by the manufacturer. Source
















