About
A torque collar is one of those mechanisms nobody questions: you twist a numbered ring, it clicks, and you hope you guessed right. Hoto has replaced the ring with a screen.
The Hoto 12V brushless drill sets its clutch on an LED display, with 30 torque settings running up to 30 newton metres, so the drill stops driving at the resistance you picked rather than at the one the collar happened to land on. That is enough to sink a screw flush without chewing up its head. Most home drills also run a brushed motor, carbon blocks dragging on the spinning core, wearing down and throwing sparks as they go. This one switches its coils electronically, so it runs steadier, wastes less charge as heat, and has nothing inside to wear out. A stepless trigger takes the 3/8 inch keyless chuck to 1,400 rpm, and the battery charges over USB-C, the same cable as a phone.
The rest of the case covers what a drill cannot. There is a screwdriver with a magnetic bit holder and ten S2 steel bits, an adjustable spanner with a 25 millimetre jaw, needle-nose pliers, and a 3 metre self-locking tape measure. The claw hammer has a magnetic nail starter that holds the nail upright for a one-handed first strike, plus a rubber cap for surfaces that mark. Eight drill bits split evenly between woodwork and metalwork. All of it lives in one grey ABS case with the buckles hidden in the sides, so the outside reads as a clean slab rather than a toolbox.
- Designed & made in
- China
- Awards
- Materials
- Battery
- 2,000 mAh lithium-ion
- Charging
- USB-C
- Weight
- 3.5 kg, full set
- Case
- Grey ABS, concealed side buckles
Figures as published by the manufacturer. Source


















