About
Every other pair of wireless headphones you have worn put its battery in the ear cups, because that is where the space is. Dyson looked at where the weight ends up instead.
The Dyson OnTrac carries its cells in the headband rather than the ear cups, which Dyson says takes 37 per cent of the load off the ears. Move the mass into the arch and everything else has to be rebalanced around it. Dyson says it built over 4,000 prototypes doing exactly that.
The cups are machined aluminium and pivot on two axes, so the cushion lands flat on the side of the head rather than catching on one edge. Inside each sits a custom 40 millimetre, 16 ohm neodymium driver running from 6 Hz up to 21,000 Hz. Most headphones quote 20 Hz to 20,000 Hz. That is short at both ends. Eight microphones listen to the noise outside and inside the cups, sampling 384,000 times a second, and the cancelling algorithm removes up to 40 dB of what they hear.
Comfort comes from the cushions as much as the balance. Knitted microfibre is air-sealed around open-cell, high-rebound foam, which holds a snug acoustic seal and keeps the bass from leaking out of it. Sensors in the cups stop the music when the headphones come off, then start it again when they go back on. The cushions and outer caps unclip too, in more than 2,000 colour and finish combinations, which is a lot of decisions to hand someone who only wanted headphones.
- Designed in
- United Kingdom
- Made in
- China
- Materials
- Weight
- 451 g
- Battery
- Up to 55 hours; a 10-minute charge gives 2.5 hours
- Body
- Aluminium, with ceramic or anodised aluminium caps and microfibre cushions
- Range
- 6 Hz to 21 kHz, 40 mm neodymium drivers
- Noise
- Up to 40 dB cancellation, eight microphones
- Colours
- 2,000+ colour and finish combinations
Figures as published by the manufacturer. Source

.webp)










.webp)




