About
Most monitor risers are a bent sheet of steel with a hollow underneath and a powder coat that chips at the corners within a year. This one is a single plate of laser-cut 5-gauge aluminium sitting on two blocks of solid American black walnut, and the finish is not sitting on top of it at all.
Blanked's Industrial Monitor Stand takes its aluminium plate through four operations before the walnut ever meets it. It is deburred, which takes the sharpness out of the edge the laser leaves behind. It is countersunk, so every fastener head drops below the surface and the top stays genuinely flat, flat enough for a keyboard or a leaning stack of paper. It is sand-blasted, which is the step that turns a mill finish matte rather than mirror. Then it is anodised in the studio's silver. Anodising is not paint: the aluminium is grown into a hard oxide skin in an electrolytic bath, so the colour is part of the surface and wears at the same rate the metal does.
The legs carry the load and then do a second job. The two walnut blocks hold the platform five inches clear of the desk and leave that gap open on all four sides, which is the storage layer Blanked designed in rather than the void a folded steel riser leaves behind. Underneath them sit 3M silicone tips, so the stand holds its place without marking the desk. The platform runs 33 inches wide by 10 deep, longer than most desk shelves, and each one is hand-assembled in small batches and arrives ready to use.
- Designed in
- Canada
- Material
- Finish
- Deburred, countersunk, sand-blasted, anodised matte silver
- Dimensions
- 33 by 10 by 5 inches
- Colour
- Anodised silver with walnut
Figures as published by the manufacturer. Source




















