About
Most trays this size begin life as a flat sheet, bent into walls and pressed into corners, which is quick and leaves a seam somewhere along an edge. This one has no edge to leave it on.
Blanked's Valet Tray is milled from a single solid block of aluminium, so the floor, the walls and the corners are the same piece of metal with nothing joined to anything. Milling works the opposite way round from pressing. It starts with a billet and cuts away everything that is not the tray, which is slow and turns most of the block into swarf, so Blanked works with its manufacturers to recycle as much of that aluminium as it can. The finished surface is anodised to a speckle silver, which is not a coat of anything: anodising grows an oxide layer down into the metal rather than sitting on top of it the way paint does.
That distinction matters because it sets what the tray does over years rather than weeks. Blanked is unusually blunt about it. Tonal variation is inherent to anodising, and the patina and small marks the tray picks up are expected and irreversible. Clean it with water or a pH neutral soap and dry it straight away, since abrasives and solvents strip the anodising off for good.
Inside are removable wool felt pads cut to the shape of the recess, so a watch or a ring lands on cloth instead of bare metal, and a 3M silicone base underneath keeps the whole thing still on a desk. Blanked started in a bedroom and now runs out of Vancouver, which is roughly the trajectory a company follows when it decides to machine desk trays out of billet.
- Designed in
- Canada
- Material
- Finish
- Speckle silver anodised
- Dimensions
- 10.5 x 6.75 x 1 in (26.7 x 17.1 x 2.5 cm)
- Lining
- Removable wool felt pads
Figures as published by the manufacturer. Source



















