About
Most grinder burrs are bolted to the shaft, and every bolt leaves a hole for stale coffee to pack into. The EG-1 has none, because its burrs are held by magnets.
Weber Workshops built the EG-1 around 80 millimetre flat burrs that clamp to the shaft on neodymium magnets instead of screws, which removes the screw holes entirely. The motor underneath is treated with the same suspicion of fixed arrangements. Most grinder motors run at one speed and sag when they hit a hard bean, so the grind drifts halfway through a dose. The EG-1 puts a PID controller between the dial and the motor: it reads the hardness of the beans as they enter the burrs and throttles current to hold the target RPM in real time. Adjustment is stepped rather than stepless, five microns a click, so you can run from Turkish-fine out to filter and come back to the same setting without purging or redialling.
The chamber is a clam shell, its top and bottom funnel caps held shut by magnets, and it opens the burr set and wiper system fully in about twenty seconds with no tools. The Mk.3 puts a Purge button in the centre of the dial: from a stop it reverses the burrs then spikes them to maximum speed to shift a stone or clear the last grounds, and mid-grind it delivers the same burst on demand. A 4 millimetre hex key swaps the whole burr set in roughly five minutes with alignment intact, which matters because there are two sets to swap between: the CORE runs espresso through filter, while the SSP-made ULTRA is cut for filter alone. Production is in Taiwan, in a factory Douglas Weber set up for the company itself.
- Designed in
- Japan
- Made in
- Taiwan
- Dimensions
- 235mm d, 245mm w, 456mm h
- Weight
- 13.5kg (30lbs)
- Material
- 80mm flat burrs magnetically mounted
- Colours
- Silver, Onyx
Figures as published by the manufacturer. Source
More from Weber Workshops
You might also like
Staff Pick

Linea Micra
$4,500
Staff Pick

Demi
$795














