About
Most grinders are designed from the outside in: a body, a motor, a hopper, and somewhere deep inside, the burrs. Weber Workshops went the other way and let the burrs decide everything else.
The Key Mk.2 is built outward from an 83 millimetre Mazzer conical burr set, which is why the whole machine measures only 109 millimetres across and sits on a base of 248 by 109 millimetres. A café-sized burr set on a counter-sized footprint happens because nothing has been added that does not have to touch the coffee. The burrs arrive factory aligned and partly seasoned, so they cut properly from the first dose, and the cutting surfaces are sealed with a food-safe titanium nitride coating rated for 5,000 kilograms of coffee. Adjustment is stepped in 5 micron increments, a range that runs from Turkish fine through to a V60 grind.
The Mk.2 carries 50 percent more torque than the first Key, from new gearing and a higher-current supply, so it works through very light roasts at 30 rpm without stalling. The other half of the redesign is cleaning. The lower funnel is held by twelve rare earth magnets and twists off by hand, the cone burr lifts out with the supplied wrench, and an oak-handled brush with a brass ferrule lives in a magnetic cubby in the body, which is roughly where you would want it.
Grounds fall into the Magic Tumbler, which catches and distributes them at once; anti-static plates and a replaceable paper wiper hold retention under 0.1 grams. That number is the argument for the whole machine: single dosing only works if yesterday's coffee is not still inside. It ships with oak accents, and the owner can swap in walnut or teak.
- Designed in
- Japan
- Made in
- Taiwan
- Dimensions
- 248mm x 109.2mm x 349.6mm
- Weight
- 9Kg
- Material
- Colours
- Snow, Onyx
Figures as published by the manufacturer. Source
Alternatives
More from Weber Workshops
You might also like
Staff Pick

Linea Micra
$4,500
Staff Pick

Demi
$795















